Chain link is the most winter-proof fence you can own, but "low maintenance" is not "no maintenance." In Ontario, most of the damage we get called out for in March traces back to five specific things you can check in one afternoon this fall. Work through this list top to bottom, in this order.
1. Grab each post and push it hard
Not a light shake — put real weight on it. You are checking for movement in the footing. A line post that shifts more than a few millimetres has soil voids around its concrete or has never been set deep enough. Ontario's frost line runs roughly 1.2 metres deep in most of the province, and any footing sitting above it becomes a lever once the ground freezes and heaves.
What to do: a slightly loose post can often be saved by tamping dry quick-set concrete mix into the soil around the footing now, while the ground is still diggable. A post moving freely at ground level is a reset — and it is far cheaper to book it for fall than to call for an emergency repair when the whole run has dominoed over in January.
2. Run the mesh with your hands, section by section
Walk the fence and press your palm flat against the fabric every couple of metres. You are feeling for three things:
- Loose fabric: if the mesh ripples or you can pull it away from the frame, the tension wire or ties have failed. Loose mesh acts like a sail in fall windstorms and transfers that load straight into the posts.
- Broken or pulled ties: every tie that has come off a post is a stress point on its neighbours. Re-tie with new galvanized aluminum ties — they cost almost nothing.
- Bent or stretched diamonds: a section someone climbed over or a hockey ball hit never tightens back up. If a stretch of fabric is deformed, the fix is replacing that panel, not straightening it.
3. Check the bottom line — this is where chain link actually fails
Most chain link failures start at ground level, not at the top. Look for:
- Tension wire: the taut wire running through the bottom of the mesh keeps it stretched and keeps animals from pushing under. If it is slack, snapped, or rusted through, the bottom of the fence is unprotected. It can be re-strung in an hour before the ground locks up.
- Bottom clearance: there should be no gap a raccoon or dog can widen. Where the mesh has lifted, pin it back down and re-secure the tension wire.
- Debris contact: soil, mulch, and especially wet leaves piled against the mesh hold moisture against the galvanized coating all winter. That is where rust starts. Rake the line back to bare ground and keep a 10 cm clear strip along the fence.
4. Inspect the galvanizing and touch up bare steel
Chain link resists rust through its zinc coating, and Ontario's road salt season is hard on it — especially on fences near roads, driveways, and walkways that get salted. Look for grey-white powdery patches (early zinc corrosion, still fine) versus orange rust (coating gone, steel exposed).
Any orange spot gets worse all winter. Sand it back, wipe it, and paint on cold galvanizing spray or a zinc-rich primer — a ten-minute job per spot in November that prevents a corroded-through post in year three. Pay special attention to gate hinges and latches, which lose their coating fastest. Oil them while you are there so they still swing in February.
5. Plan for snow: gates, plows, and shedding roofs
Gates: open each one fully and let it swing on its own. A gate that drifts closed or open has a sagging hinge side, and a few centimetres of ground heave will bind it solid by mid-winter. Tighten the hinge bolts and check that the frame's diagonal brace cable (on wider gates) still has tension.
Plow lines: if a snowplow or snowblower passes anywhere near the fence, mark the corner and end posts with tall stakes before the snow flies. An operator who can see the line will save your fence; one who can't will take out the first 3 metres of mesh without knowing.
Roof dump: if a roof section sheds snow onto the fence line, that one panel takes tons of load every thaw. If you know the spot, consider where the snow actually lands — moving the fence line even half a metre, or adding a stronger terminal post, prevents a repeat every single year.
The 30-minute version
If you do nothing else: push the posts, re-tie loose mesh, rake a clear strip along the bottom, oil the gate hinges, and stake the plow line. That hour of work covers the failures that cause 90% of chain link repairs across Ontario each spring.
When a repair is not a Saturday job
Resetting posts properly means setting footings below the frost line with concrete — that is a crew-and-auger job, not a weekend one. The same goes for re-tensioning long runs, replacing fabric panels, or anything on a shared property line. Safefence installs and repairs chain link fencing across Ontario, and fall bookings are easier to schedule than spring emergencies.
Found a post that moves or a run of mesh that sags? Send us a quote request with a photo and we will tell you what it needs — before the frost decides for you.